WETNESS 

SENSING

systems

For appliance or area protection

BUY NOW

AT601

FROM ONLY NZ$243

WETNESS SENSOR with AUTOMATIC SHUTOFF VALVE

WIRELESS WETNESS SENSING

SIGNAL STATIONS

WS1 / WS2

FROM ONLY NZ$164

 

AT601-S15 - The Beaver - Wetness Sensor with automatic Shutoff Valve

The Beaver is a Wetness Sensor connected to an automatic Water Shutoff Valve. It is designed to detect water that may leak from Hot Water Systems, Washing Machines, Dishwashers, Water Dispensers, Laundries, Basements or any floodable area, where there is the possibility of a leaking appliance or broken pipe joint flooding the premises. Internal Use only. 
 
The Beaver is available with a selection of quality shut off valves, linked by a cable to a Wetness Sensing Control Unit.

• Wetness Detection System for automatic shut-off of incoming water supply in event of a leak

• Protects Water Heaters, Washing Machines, Dishwashers, Water Dispensers,  Laundries, Ice Makers etc

• Powered by 9V alkaline battery (supplied)

• Audible alarm for low battery warning and water OFF alert

• Automatic valve self testing facility every two weeks

• Very simple reset of system once leak is repaired using the Reset Button

• Choice of 15mm / 1/2"  or 20mm / 3/4" Commercial quality Stainless steel  or 25mm / 1" PVC shut off valves 

• Simple Manual Override Facility in the event of Control Unit or Battery failure

• Very Simple to install (NOTE: For Indoor or Covered use only)

• Certified to meet AS5300.476 and AS4020 Watermark approved

 

WS1 -  Squirrel -  Wireless Wetness Sensing Signal Station (freestanding)

The Squirrel is designed to work with the AT301 Leak Detection system, to detect wetness and then signal back to the Control Unit and Shutoff Valve to shut off the water supply to the property to minimise the potential water loss. The WS1 Squirrel can be used where the location of the appliance will not affect the ability of the radio signal to reach back to the Control Unit.
• The Squirrel can be used to signal the AT301 Control Unit.
• Powered by 2x AA Alkaline batteries (supplied)
• Low battery warning indicator
• Audible warning when wetness is detected
• Skirting Board mounting bracket supplied
The Squirrel is not available in all markets and may be only installed
where its radio signal can reach the Shut off Valve without being
impeded by extensive walls or distance or shielding.

WS2 -  Ferret -  Wireless Wetness Sensing Signal Station (cable sensor)

The Ferret is designed to work with the AT301 Leak Detection system, to detect wetness and then signal back to the Control Unit and Shutoff valve to shut off the water supply to the property to minimise the potential water loss.
 
The Ferret can be used where the location of the appliance may limit the ability of the radio signal to reach the Control Unit. In that case the sensor can be placed in the area to be monitored, and the actual control box for the Wetness Sensor can be located away from the appliance to make sure the signal can reach back to the Control Unit and Shutoff Valve.
 
• The Ferret can be used to signal the AT301.
• Powered by 2x AA Alkaline batteries (supplied)
• Low battery warning indicator
• Audible warning when wetness is detected
• Skirting Board or Wall mounting bracket supplied
 
The Ferret is not available in all markets and may be only installed
where its radio signal can reach the Shut off Valve without being
impeded by extensive walls or distance or shielding materials.